These covers have the most durable hook and loop closures of any diapers that I have seen. The loop part of the closure does not get that "fuzzy" look to it. After months of use it still looks like new. The cover is made out of a soft polyester with a polyurethane waterproof coating. It is fully lined with a polyester mesh to help keep your prefold diapers in place without pins - this feature is especially good for active babies. Soft elastic waist and leg openings for a snug fit while still allowing your baby to move freely and comfortably. The elastic does a great job of keeping messes inside the cover. I don't recommend using these covers for use at nighttime, it seems that after being in contact with moisture for so long, the elastic may cause pee to wick onto your little ones pajamas. If you don't plan to leave your little one for a long time without a change though and you want a cover that will keep your diaper in place, these are a very durable cover for a great price. The Gerber covers fit a bit smaller than the manufacturers size range listed below. Machine wash and hang or machine dry. Available in white.

When trying to decide upon a cover size, start with the suggested weights and then see if the waist, leg and rise measurements of your baby fall into the range of that cover. If you start with the measurements you may end up with a cover that is way too big. For all the velcro covers, you are looking for waist and leg measurements that fall in about the same place in the range. The smallest leg measurements were taken when the cover was fastened on the smallest waist setting. If your baby’s waist measurement is on the lower end of the range and the leg measurement is on the higher end of the range, the cover will probably be too tight at the legs. Check the size chart to compare the Gerber covers with the other covers that we sell. Made in the US for Gerber.